Mitered Square Blanket
Garter squares that decrease to a point, joined as you knit. Each square is a short, satisfying project.

- Yarn
- Worsted (4). Self-striping or variegated yarn makes each square stripe on the diagonal.
- Needles
- US 8 (5 mm) straight or circular
- Sizes
- Throw 48 × 60 in (122 × 152 cm): 8 squares × 10 squares of 6 in (15 cm)
- Example gauge
- 18 sts and 36 rows = 4 in (10 cm) in garter
- Yarn needed
- About 3,000 yd (2,750 m) worsted: each 6 in square uses about 37 yd.
Do the math
The examples use the gauge above. Put your own swatch into the gauge calculator first, then use your numbers in each formula.
| Step | Formula | Example | Tool |
|---|---|---|---|
| Stitches per side | square side × sts per in | 6 × 4.5 = 27 sts | Cast-On Calculator |
| Cast on per square | 2 × sts per side + 1 centre st | 2 × 27 + 1 = 55 sts | By hand |
| Squares needed | (width ÷ side) × (length ÷ side) | 8 × 10 = 80 squares | By hand |
Materials
- Worsted (4) yarn (see yarn needed)
- US 8 (5 mm) straight or circular
- Tapestry needle
- 1 marker for the centre stitch
Gauge swatch
Knit one test square from the recipe below. If it measures 6 in on each side, your gauge is right.
Instructions
First square
Cast on the square count (example: 55 sts). Mark the centre stitch (example: stitch 28).
Row 1 (WS): Knit.
Row 2 (RS): Knit to 1 st before the centre stitch, s2kp (slip 2 together knitwise, k1, pass the 2 slipped sts over), knit to end. 2 sts decreased.
Repeat rows 1–2 until 3 sts remain, ending with a WS row. Next row: s2kp. Fasten off.
Rest of the first strip
Squares 2–8: cast on the per-side count + 1 (example: 28 sts), then with the RS facing pick up and knit the per-side count (example: 27) along the right edge of the previous square. Work as for the first square.
Later strips
First square of each strip: pick up the per-side count along the top of the square below, then cast on per-side + 1.
Other squares: pick up per-side along the left neighbour, 1 st in the corner, per-side along the square below (example: 27 + 1 + 27 = 55).
Finishing
- Weave in ends as you go, one square at a time.
- Optional garter border: pick up 1 st per ridge / per stitch all round and knit 8 rounds of garter, increasing at the corners.
Designer’s notes
- Change the square size to 4 in and you get 18 sts per side / 37 to cast on (4 × 4.5 = 18).
- Always pick up with the RS facing so the pick-up ridge lands on the back.
Counter set-up
Counter 1: squares done (goal 80). Counter 2: ridges in the current square.
Open the row & stitch counter for several counters, or use the quick one below.
Tools for this pattern
- Gauge CalculatorEnter your swatch counts to get stitches and rows per 4 in (10 cm).
- Cast-On CalculatorEnter your width and gauge; it rounds to the stitch multiple for you.
- Yarn Quantity CalculatorPick the project, size and yarn weight to get total yardage and skeins to buy.
- Row & Stitch CounterSet up the counters listed below; the screen stays awake while you work.